How to Paint Stripes on Furniture
Adding stripes is another quick and loose style to style and deck wooden furniture . Painting bound chevron on enamel or antiqued furniture can add distinction to flat airfoil – use one lean molding bar or paint multiple stripes or geometrical borders .
tabletop , president rear end , and similar areas are good candidates for striping , but any flat surface can be decorated with stripes . utilise high - gloss or semigloss enamel , slightly thinned ; check that it ’s compatible with the existing goal .
Application Techniques
Freehand Striping : Freehand stripes take a steady hand and a good light touch , but they are n’t difficult on a fairly small small-arm . The surface to be striped must be clean ; remove all wax and dirt . utilize a good - quality artists ' encounter , with a low diameter and a skillful point . pattern undress on a piece of cardboard before you work on a piece of furniture .
Stripes close to the bound of a surface can be applied without a straightedge or other templet . apply the brushing with your ovolo and first two finger’s breadth and rest your other two fingers on the edge of the surface ; keeping the brush steady on the surface , describe your hand along the edge . This method is effectual for border stripes on curved or straight surfaces . For band too far from a straight edge for this technique , use a yardstick as a guidebook to draw your hand along ; have an assistant hold the peg in position as you paint .
Apply enamel carefully , loading the brush enough to make a complete stripes but not enough to blob or dripping . Keep your pressure stiff as you soak up the clash along the border of the surface ; pattern on composition board to get a tone for the proficiency . If the brush does n’t hold its point or spreads out too far , try turning it slightly as you depict it along . This will re - make the brush as you knead .
For double stripes or designs with more than one colour , get each stripe dry completely before you paint the next one . work on from the inside stripe out to avoid smudging .
videotape Striping : On retentive boundary , or for broad stripe , use painter ’s tape to set the stripes . The airfoil must be clean , with all wax and dirt removed . Carefully press the magnetic tape along the aerofoil ; make certain it ’s straight , and at a ordered distance from the edge . Seal the edge of the tapeline carefully to keep the paint from seeping under it ; constrict each tape edge firm all along its length with your thumbnail or the tip of a putty tongue .
put on the enamel with a good - timbre artists ' brushing , around the same width as the masked grade insignia . Use enough paint to cover the surface completely , but smoothen it out well ; do n’t let the stripe get thick or uneven . Let the pigment dry out altogether . Then remove the tape , pulling it gently away from the surface . Do not leave behind the tape on the surface for more than 12 hours , or it may damage the finish .
For double chevron or intention with more than one vividness , let each band dry out completely before you tape the next one . Apply tape very cautiously where stripes cross , to keep it from damage the early stripe . workplace from the inside of the surface toward the edges .
Protecting the Surface
To preclude damage to the stripes , the surface should be sealed with varnish . utilise a coat of varnish like a shot over the stripes .
If you are wreak with cheap furniture , decal are another option for sprucing up your musical composition . Check out when and how to use decalcomania in the next section .
